Skeletime® Professional 12 Recommended Steps
1) Assembly of the Totem pad on the sander.
2) Apply the three Skeletime® Savers pressed firmly into the back part of the green, red, blue Skeletime®.
3) Red HARD (suitable for smoothing the curved parts of the stucco with just 1 pass):
4) Blu MEDIUM (Suitable for smoothing undercoats/primers with just 1 pass or paints to be matted with perfectly preserved edges):
5) STRONG RIGID Green (Suitable on the pre-phase of the stucco to level the metal painting phase or smooth the planar parts with Stucco or Primer with just 1 pass):
6) White RUBBER INSERT (Transforms the Totem pad for standard use when necessary) It is to be used without Skeletime Saver:
7) BLACK SPONGE INSERT (Suitable for additional surface finishing when necessary) To be used without Skeletime Saver:
8) When you install Skeletime® on the Totem pad, you must press them firmly.
9) When removing, hold a finger on the backing pad and remove Skeletime® + Saver from the crescent. The Saver must always remain together with the green, red, blue Skeletime® on its back part, which is the one that adheres to the Totem pad.
10) To use, lower the speed of your sander to 5/6000 rpm (about half).
11) Use the sander without pressure and as if it were a manual pad, i.e. long lateral, horizontal and vertical passages but following the profile of the vehicle.
12) Always use a sanding control light at each step.
By magic you will obtain precision sanding with perfect profiles!